Just finished a stock set for a BM14 mod.
- Butt end milled and shaped to accept M14 butt plate.
- Finger grooves
- Mag well cut out
- Clip latch cut out
- Rear sling swivel cut milled and reshaped to allow for side swivel
http://s1307.photobucket.com/user/th...?sort=3&page=1
What do you think?
2014-04-23 17.10.43.jpg
2014-04-23 17.11.51.jpg
[SIGPIC]
Fine looking stock. Does it fit a Mini G also?
"Are you my pal, Danny?"
This is inletted and would drop in a mag fed g. I make them like this for standard g without mag too
[SIGPIC]
I think they look good Sean.
So how how hard was it perfecting the inletting for the buttplate , much of a learning curve?
"I am the master of my unspoken words, and a slave to those that should have remained unspoken. ...
"Official 2010 Mini-G & 2011 Summer Postal Shoot Biggest Looser"
It's not idiot-proof, but not as bad as I had thought it would be. Obviously, it has to be done on a mill. No way to do it otherwise. The first few took me forever, mostly because I was afraid of messing up. Now, they aren't too bad. A little easier than cutting and reshaping for a BM59 butt. Worst part is all the cuts are in a high-exposure area so there isn't much room for error.
[SIGPIC]
Nice piece of wood also.
Μολὼν λάβε
VFW life member.
NRA life member.
Very nice work. Hope you sell a bunch.
Yes, beautiful looking stock. Do you have a website?
I bought a similar stock from Sean, finger grooves, magwell cut, just not the m14 buttplate or side swivel, I do have a BM59 side sling stock feurrel that is going on it though. It's at Tim's right now for a Mag Fed Mini-G build.
I got it unfinished because I like the smell of linseed oil.
I'm sure it's going to be a looker when it's all done...
2014-03-26 09.23.54.jpg
I would assume it's cool if I post his site..
http://www.thestockemporium.com/
Posting Permissions
Reply With Quote
