Has anyone had trouble with rounds not feeding properly into an 03A3 when using stripper clips?
Has anyone had trouble with rounds not feeding properly into an 03A3 when using stripper clips?
They've always worked fine in mine.
"The advantage of being armed, which the Americans possess over the people of almost every other nation ... forms a barrier against the enterprises of ambition, more insurmountable than any which a simple government of any form can admit of." -- James Madison (1788)
John
Don't worry if plan "A" fails, there are still 25 other letters in the alphabet.
Looking for S/A bayonets s/n 922033 & 1045220
Proud Member of M1CC #112
No problem with US clips. Ive heard the Swedish clips work well as mentioned by jak. There are aftermarket clips by Clemsul that were popular when bolt guns in 308 ran in NRA high power. They'd be good also.
I have a box of 6.5mm laddram (Swedish) stripper clips. I recently filled up one with 5 rounds of HXP, placed the stripper clip into the stripper clip location and seated the rounds.
When I closed the bolt, no cartridge was stripped from the magazine into the chamber. I retried this several times, to no avail. What could I have done that prevented the rounds from chambering??
This is a rebuilt 03A3. When I have hand loaded the HXP every thing went smoothly: IE, rounds chambered and extracted as one would expect.
Steve
I never had a problem like you described. It sounds like the rounds are not completely touching the top of the receiver.
Load the rounds using the stripper clip. Look at the top round. The entire length of the top round should be touching the
receiver along the right hand side. There should be no gap. It sounds like there is a small gap near the rear of the shell and
the receiver and the bolt is riding over the top of the shell.
Remove and reinstall the trigger guard and try loading the shells again.
Also try stretching the magazine spring a bit before you reinstall the trigger guard.
Last edited by jak; 10-09-2014 at 07:31 PM.
John
Don't worry if plan "A" fails, there are still 25 other letters in the alphabet.
Looking for S/A bayonets s/n 922033 & 1045220
Proud Member of M1CC #112
Ok, I'll give that a try.....Thank you for your input.
Steve
I know on the the 03 there is a magazine cut off. I do not know if they continued with it on the 03a3 but if you have the magazine cut off engaged the rounds will do exactly what you are describing. The lever on the left side of the receiver should be positioned where the lever reads off for you to load out of the magazine. If it is off you are feeding single rounds and keeping the 5 rounds in reserve. Try flipping the lever to the opposite position it is in now. It is very possible the last time you took the bolt out you put the magazine cut off lever in the single shot position.
Mack
If the cut-off is engaged the bolt does not go all the way back. Would it not block the guide/prevent the rounds from loading?
John
Don't worry if plan "A" fails, there are still 25 other letters in the alphabet.
Looking for S/A bayonets s/n 922033 & 1045220
Proud Member of M1CC #112