Spin on a G.

[timshufflin]

Mr. Wilson, no bend. I have to bend it to be straight.

[ordmm]

First off, great job Tim! Now I guess you have the MINI59/14.

Anyway, we are trying to get a run done right now of a muzzle break to go with the 59 gas cylinder. It will be similiar to the Smith break...but with the porting of the BM59E model break. The will be less than 4 inchs long. Would post a pic, but the prototype is back at the shop.

Hope this post is OK by Tim.

Greg

[Colter44]

Mr. Wilson, no bend. I have to bend it to be straight.

If there is no bend in the op rod on this setup, will an M14 stock configuration work on this rifle?

[Rush2112]

Muzzle breaks on the way....

I would like to get the shorter one

[timshufflin]

The M14 still would not work Colter without some serious mods.

[Colter44]

Couldn't be that easy huh lol.

[Comms325]

Standard Parts sells the BM59 Gas Tube for $115.00

[mikebaker1129]

The short BM59 breaks are done very well. I am running one of the prototypes on my M14 mag fed rifle now.

[dogboysdad]

I don't like that look. Looks like a Yugo SKS,

[grumpyoldretiredcop]

Sent my rifle, a Standard Parts gas cylinder, original Beretta gas plug and front sight, and a trimmed down tricomp (it was demilled by cutting the tip, had no choice but to shorten it) off to Tim for Mini-G conversion with this gas system. I'm especially liking the idea of a straight op rod and like the way it looks, too. Can't wait to see how it comes out!

BTW, if anyone's looking for a BM59 spindle valve, I have one left over from this. Unfortunately, no other unused parts survived the demiller's shear.