New Stock set for BM14

[seaninmich]

Just finished a stock set for a BM14 mod.

- Butt end milled and shaped to accept M14 butt plate.
- Finger grooves
- Mag well cut out
- Clip latch cut out
- Rear sling swivel cut milled and reshaped to allow for side swivel

http://s1307.photobucket.com/user/thestockemporium/library/BM14%20Stock%20Set?sort=3&page=1

What do you think?


1405

1404

[melloman]

Fine looking stock. Does it fit a Mini G also?

[seaninmich]

This is inletted and would drop in a mag fed g. I make them like this for standard g without mag too

[Orlando]

I think they look good Sean.
So how how hard was it perfecting the inletting for the buttplate , much of a learning curve?

[seaninmich]

It's not idiot-proof, but not as bad as I had thought it would be. Obviously, it has to be done on a mill. No way to do it otherwise. The first few took me forever, mostly because I was afraid of messing up. Now, they aren't too bad. A little easier than cutting and reshaping for a BM59 butt. Worst part is all the cuts are in a high-exposure area so there isn't much room for error.

[LEAD POISON]

Nice piece of wood also.

[TommyD11730]

Very nice work. Hope you sell a bunch.

[Jgun]

Yes, beautiful looking stock. Do you have a website?

[jbkf1003]

I bought a similar stock from Sean, finger grooves, magwell cut, just not the m14 buttplate or side swivel, I do have a BM59 side sling stock feurrel that is going on it though. It's at Tim's right now for a Mag Fed Mini-G build.

I got it unfinished because I like the smell of linseed oil. :)

I'm sure it's going to be a looker when it's all done...

1406

[jbkf1003]

I would assume it's cool if I post his site..
http://www.thestockemporium.com/

[cuppednlocked]

Nice looking stock Sean!

[HerkyBird]

Nice piece of wood also.

That's what she said.

That is a nice piece of work, Sean. I'd love to build a Garand, standard or mini g, with my boy when he gets older. I know where I'll be getting my stock.