PDA

View Full Version : CMP Barrelled Receivers: general condition?



R2.0
08-10-2011, 11:27 AM
I bought 2 of the barreled receivers that the CMP had a few years ago. They were the $85 ones, and since I was buying for the receivers only I didn't really pay attention to the bore when I selected them. And of course things got delayed so I put them in the safe and forgot about them.

FF to now and I have a side project that requires a barrel blank with a .308 bore (for the inquisitive, it's a rebarrel of a Remington 580 to shoot 7.62x25). I only need 16", so I thought about using one of the barrels from one of the BR's. I would be cutting off the chamber section anyway; the question I have regards the general condition of the bores. Have these barrels proved to be usable with some work, or are they completely shot out? I realize that I won't really know until I get the barrels dismounted (or Tim does - at least one of these is slated for a tanker/BM59 project), but I'm asking in more general terms. If it's doable I'll hang tight; if it's a lost cause I'll keep searching for a cheap .308 blank for my project.

Thanks for any advice you can give.

R2.0

Prince Humperdink
08-10-2011, 11:55 AM
I bought 4 and never had to replace a Barrel.My 4.3 had a Mint 3/56 Barrel,3.4 mil(SA-52 rebuild)had a mint SA 1/51 barrel,2 million had an unknown barrel mfgr w/dark Bore that cleaned up well and shot great,and a 1 mill with a barrel that I don't recall,but it shot great.check them first,and if You just need part of a barrel check these out...
http://www.gunpartscorp.com/catalog/Detail.aspx?pid=1086140&catid=11884
http://www.gunpartscorp.com/catalog/Detail.aspx?pid=1086160&catid=11884

BTW,Welcome.
Ryan

checkmate19
08-10-2011, 12:34 PM
I purchased several of the 125. ones and a few of the barrels were very bad inside and with suggestions here I used Kroil and they look great now. Good luck

paid4c4
08-10-2011, 01:09 PM
I bought four of them, three had good barrels one did not. I still have the one with the bad barrel and plan to use it for an upcoming build with one of the NOS SA barrels from last year.
Bill

R2.0
08-10-2011, 02:12 PM
I bought 4 and never had to replace a Barrel.My 4.3 had a Mint 3/56 Barrel,3.4 mil(SA-52 rebuild)had a mint SA 1/51 barrel,2 million had an unknown barrel mfgr w/dark Bore that cleaned up well and shot great,and a 1 mill with a barrel that I don't recall,but it shot great.check them first,and if You just need part of a barrel check these out...
http://www.gunpartscorp.com/catalog/Detail.aspx?pid=1086140&catid=11884
http://www.gunpartscorp.com/catalog/Detail.aspx?pid=1086160&catid=11884

BTW,Welcome.
Ryan

The one's demilled to 15" are a killer - under $10, but you need to permanently attach a flash hider/comp. I swear the ATF is [expletive deleted].

Although, if I silver soldered on a bm59 tri-comp...

R2.0
08-10-2011, 02:14 PM
I'm encouraged. I might just need to borrow my buddy's tools and break these apart and take a look. Now if I can clear a way to the safe...